Bronkhorst Multibus Bedienungsanleitung PDF herunterladen (Seite 36)

BRONKHORST®

Page 36 Operational instructions for digital multibus instruments 9.17.023

9 SPECIAL PARAMETERS

Data Type

Range

read/write

Secured

DDE

Proc/par

9.1 RESET

Unsigned char

0…5

114

115/8

Parameter to reset program, counter or alarms. Default value = 0.

Value

Description

no reset

reset counter value (no mode change) or common reset

reset alarm

restart batch counter

reset counter value (counter off)

reset module (soft reset)

reset alarm info error bit (bit 0) See ‘Alarm info’

reset alarm info warning bit (bit 1) See ‘Alarm info’

To make sure the parameter is accepted send a 0 first.

9.2 I

NIT

RESET

Unsigned char

0…255

0/10

( key parameter)

Init and reset security key command for network/parameter settings.

Write 64 to enable changing of secured parameters. Write 82 or 0 to disable changing of secured parameters.

When an instrument powers-up this value will be reset to 82 automatically.

9.3 WINK

Unsigned char

0…9

0/0

Unsigned char in range ‘0’...’9’ send to this parameter lets the instrument which is addressed wink for several seconds for

tracing the physical location. Type of winking depends on instrument. This will be either with red and green LED turn-by-

turn or with special characters on a display. Default setting = 0.

9.4 IOSTATUS

Unsigned char

0…255



114/11

The parameter IOStatus (parameter 86) is used to read and enable / disable the physical jumpers and micro switch.

Bit

Decimal Value

Explanation

Read/Write

Default

true = read ‘special purpose’ jumper

not used

true = read ‘analog mode jumper’

true = read ‘micro switch’

special purpose jumper off/on

R(W)

(0)

internal initialization jumper off/on

R(W)

(0)

analog mode jumper off/on

R(W)

(0)

128

micro switch off/on

For bits 4,5,6 the jumper can be a real jumper on the pc board or a virtual jumper (MBC3 type).

In case of a real jumper the bits 4,5,6 are read from the pc board.

In case of a virtual jumper the bits 4,5,6 are set by firmware (MBC3 type).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

Bronkhorst Multibus Bedienungsanleitung Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Bronkhorst Multibus